Additionally, this stock can be used for the Hall Carbine by requesting that the trigger plate not be inletted.īy shortening the forearm and using a modified dovetail bit, the ramrod channel can be fitted for the ramrod bayonet. By requesting that the inletting for the trigger guard plate be omitted, the stock can be reworked to fit the M Hall. It has been inletted for the barrel, receiver.īuttplate and ramrod- channel.
This stock was copied from an excellent quality original model.
Special orders for extra wood remaining around the rear portion of the lock mortise on theto finish the Model variation, are available upon request. Each of these stocks were copied from excellent quality original guns, with the barrel final fit and the remainder of the other parts inlet.Įach of these stocks was copied from excellent quality original guns with all parts final fit except the locks on the model, which are cut. The stock forearm is long enough to permit the use of up to a inch long barrel. The inletting for the buttplate and trigger guard is undersize and requires detailed fitting of these parts. Therefore, only the lock internals are inlet, leaving enough wood to final inlet the variety of original lock plates. Since the musket parts were all hand-made, almost all parts vary in size from one musket to another. This high quality stock is a composite of four original stocks and can be finished to the pattern carved or can be varied to copy a variety of slightly smaller original individual stocks. Please contact me by any of the means above for quotes on time, prices, and any additional information required. In addition to all of the available stocks patterns listed below, we can serve small numbers of replacement stocks directly from the stocks from your original guns with modification as specified. Experienced gunsmiths have final-assembled several of the models listed below with all original parts en less than 12 hours. The ramrod hole is drilled in all models originally having ramrods. All external wood surfaces are planned to be. Most parts fits are press in fit with original parts. Only the inter portions of the buttplate and the square portion of the breech, where the round cutter can not cut a square corner, need to be fit on all of the stocks. All metal parts fits are planned to within. The wood for the Austrian and German produced weapons will be beech, unless otherwise specified. The wood for all of the American and British produced weapons is veneer grade, kiln-dried American black walnut unless otherwise specified. All of the above replacement stocks are being produced from master patterns copied directly from top quality original guns of each type.
Replacement stocks for several of the most common reproduction of the mid-eighteenth century muskets are also available. Dunlap Woodcrafts is proud to announce the availability of direct copies of stocks for many popular U.
0 kommentar(er)
